The Flow Max RV Fresh Water Pump # LC689054 is wired for an AC connection. If your current water pump is wired for AC then you would be good to go with this pump. If it is wired for a DC connection then you would have to rewire your set-up or go with a DC option like the Seaflo Diaphragm Pump # SE24FR. The more common set-up is DC.
If you wanted to send me the make and model number of your current pump, I could check on whether you have an AC or DC pump currently. view full answer...
To replace your Atwood GC6AA-10E water heater I recommend the Furrion RV Tankless Water Heater # FR48SR. This unit is tankless and widely surpasses the performance of the other water heaters we currently carry. This unit is powered by gas but does require electric for the controls. The other models we carry, like the # DMC74FR have electric assistance for heating but can't solely run off of electric.
The on-demand hot water and ability to set the temperature to a specific degree instead... view full answer...
I still recommend the Furrion water heater but you may need to choose a different door size with it to fully cover your current cutout hole. The specs I'm seeing for the Atwood GCH10A-4E show it being 16" W x 15.5" T so you could possibly get away with using the # FR98SR, which comes 16" x 16" door.
I recommend double checking with your tape measure and if you feel it won't fully cover the gap or maybe the old door stuck out just a bit further and you don't want to have a wear line showing... view full answer...
The 9" Round Foot Pad # LC314667 is actually meant to be used to replace rectangular 5th wheel RV landing gear foot pads.
Since most rear foot pads connect to a round tube you are probably going to need part # LC377962 instead. view full answer...
I understand your concerns but do not have experience with that model, we carry the Furrion RV Tankless Water Heater, # FR93FR that is a 60,000 BTU unit with measurements of 19-3/16" deep x 12-5/8" tall x 12-13/16" wide. Please compare these measurements to those of your 2005 Winnebago Journey Motorhome.
You may also want to consider the new Ventless Excel RV Tankless On-Demand Water Heater, # EX93FR. This has overall dimensions of 11-5/8" wide x 14-5/8" tall x 4-1/2" deep. While... view full answer...
We do have replacements for a Coleman Mach Air AC, so long as your current thermostat and relay box are working, and so long as it is not a 6000 Series or 7000 Series, which based on my research your 8633B876 unit is not, though you will want to verify that.
There are 13,500 Btu or 15,000 Btu units and either Black or White in color:
- Black: Advent Air Replacement RV Air Conditioner for Coleman Setup - 15,000 Btu # ACCOL150B or 13,500 Btu # ACCOL135B
- White: Advent Air Replacement... view full answer...
Yes, the Excel RV Tankless On-Demand Water Heater # EX93FR can be installed in a 2008 Winnebago Journey 39Z. The fittings and connections may not be the same, so worse case scenario you might need some simple adapters you can obtain locally. The dimensions are likely different as well with the tankless heater measuring 11-5/8" wide x 14-5/8" tall x 4-1/2" deep.
It is also important to note that installation and service must be performed by a qualified installer, service agency or the gas... view full answer...
The AT94023 is the correct replacement but unfortunately all Atwood water heater units are currently unavailable but I do recommend the Furrion RV Tankless Water Heater - Gas - Automatic Pilot - 60,000 BTU - 16" x 16" Door Item # FR98SR instead. It has similar dimensions at 12-5/8L x 12-13/16W x 19-3/16D so you'll need to make slight alterations to your cutout hole to fill in the gap but the performance output of this unit will be worth the work. The on-demand hot water and ability to set... view full answer...
The snap pads that you need will be determined by the size and shape of your leveling system feet. The SnapPad XTRA Jack Pads # SP54FR4 will fit 9" round feet. The SnapPad EQ Compact Jack Pads # SP24FR4 fit 7" square feet and the SnapPad EQ Plus Jack Pads # SP64FR84 fit 10" round or octagon feet. I have linked our selection of snap pads if you have a different size/shape. You can either use that link or provide me with the leveling system you have or the size/shape of your leveling feet... view full answer...
Yes, the Voyager RV Side Camera w/ Night Vision - Passenger's Side item VCMS50RGP is the correct replacement for your Voyager AOM713 3 camera system.
We offer multiple replacement options for this system and yes the wires are all compatible.
The Voyager RV LCD Observation Monitor - 7" Screen - 3 Video Inputs item # VO34FR.
Voyager RV Side Camera - Driver's Side item # VCMS50LGP. view full answer...
Yes, the Ventline Ventadome Roof Vent part # V2119-603-00 is designed to wire to a switch like the one you mention part # VC0533-03-A. I have attached a wiring diagram for your reference.
The Ventadome Roof Vent also comes in white part # V2119-601-00. view full answer...
Go To Results